ALaW - K L

K - Stamping - with foam and underglaze

Wanting to carve into foam I cut a square with a hacksaw blade. I first tried the dremel to shape a K, not to successful I might add! It just tore and grabbed at the foam. My second and successful attempt I used a hot soldering iron to melt away the foam.

After a few test runs and getting the correct consistency with the underglaze, I felt confident enough to stamp the K. The foam is pressed very lightly into the container of underglaze, a gentle hand is needed in both soaking up the colour to stamp and when stamping, so it doesn't go into the negative space and leave behind a blotchy letter.
Phew! All good, I had to hold my breath while doing this one!

L - Stamping - with foam and porcleain slip

Once again the letter is burnt out in the foam using a hot soldering iron (...carefully and not inhaling the toxic fumes!)* and is cut to make a square.

Reverse to the K tile, a thick and smooth porcelain slip is brushed onto the clay tile first. The foam sponge is gently pressed onto the tile to soak up the excess slip creating a nice texture surrounding and the letter is left smooth and slightly three dimensional. Extremely hard to see in this photo, a close look you can see the shiny bit being smooth.

Almost finished K & L, I intend to sharpen the lines on K with black underglaze in a fine nib bottle and outline the L (now bone dry is almost impossible to see).

*Hot soldering iron and foam is not really an ideal technique and I wouldn't use it again or recommend anyone to use it. As this is an exercise in experiementation was the only reason for attempting. I found it to be very challenging not to over melt the foam and toxic.